David PA7LIM presents new version ambe server for linux

AMBEServer 3003 for Linux

This software converts an AMBE3003 to three AMBE3000 AMBEServers.

Install the latest Raspbian on a Raspberry PI.

https://www.raspberrypi.org/software/

  • This software does not convert one AMBE3000 to three AMBE3000!!
  • The AMBEServer3003 software is free but without support!!
  • Make sure you have a 2.1A power supply. ( not a cheap 2.1A power supply )
  • Only start with this installation if you have knowledge of Linux
  • Do not install the graphical version of Raspbian. This gives a lot of overhead
  • Make sure you installed the latest version of Raspbian
  • Change the default pi and root user password!!
  • Do not forget to extend the disk partition in the raspi-config

Download the AMBEServer3003 install script

wget https://www.pa7lim.nl/AMBEServer3003/installscript.sh -O /tmp/installscript.sh



Install the AMBEServer3003 software:

sudo bash /tmp/installscript.sh 

Configure AMBEServer3003

Edit the configuration file.

/usr/local/AMBEServer3003/config.ini

The default port for the AMBE3003 stick is /dev/ttyUSB0 when no other devices are connected to the computer.

[SERIAL]
comport=/dev/ttyUSB0
[AMBEServer]
UDPPort1=2460
UDPPort2=2461
UDPPort3=2462

Start the AMBEServer3003:

#To start the AMBEServer3003
systemctl start AMBEServer3003

#To enable AMBEServer3003 at boot
systemctl enable AMBEServer3003

Have fun !!
David PA7LIM https://www.pa7lim.nl/ambeserver-3003-for-linux/



https://radio.xreflector.es/index.php/hazte-socio-colaborador-de-x-reflector-spain/

Visitas: 153

Por EA7IYR

Deja una respuesta