[FTX-1_ENG_Firmware_update_20260316.]zip Contains:
・DISPLAY : FTX-1_DISPLAY_V0109.SFL (3/13)
・MAIN : FTX-1_MAIN_V0112.SFL (New)
・DSP : FTX-1_IFDSP_V0107.SFL (3/13)
・SDR : FTX-1_SDR_V0106SFL (3/13)
・OPT : SPA-1_CTRL_V0113.SFL
FTX-1 series USB Driver Virtual COM Port Driver (Windows 11/10)
FTX-1 Series Firmware Update Manual (3/14/2026)
FTX-1 Firmware Update Information (3/16/26)
FTX-1 [FTX-1_ENG_Firmware_Update_20260316.zip] 3/16/26
USB Driver Virtual COM Port Driver (Windows 11/10) Information
(FTX-1)
OPT V01-13 → V01-13
FTX-1_ENG_Firmware_Update_20260316
Important: Please read the FTX-1 series Firmware Upgrade Manual,
Firmware_Ver_Up_Manual_ENG_FTX-1_2511-C.pdf
Update Details (Web Release) (March 16, 2026)
・Fixed an issue in the MAIN software (Ver 01-11), released on March 13,
where the specified transmit output power was not achieved in the 144 MHz
and 430 MHz bands when an SPA-1 was connected.
・Added support for WIRES-X.
・Fixed an issue preventing manual tuning in CW mode when using the ATAS-120.
・Fixed an issue where the scope display would invert the UPPER/LOWER
indications during SSB transmission in the 50 MHz band.
Note: After completely installing the firmware, the FTX-1 must be reset.
Refer to the FTX-1 series Operating Manual Page 79.
Or refer to the Firmware_Ver_Up_Manual_ENG_FTX-1_2511-C.pdf
If you already have the above firmware versions, it is not necessary to update the FTX-1 again.
We hope this new firmware will increase your enjoyment of your FTX-1. Thank yX-1_DISPLAY_V0109.SFL (New)
・MAIN : FTX-1_MAIN_V0111.SFL (New)
・DSP : FTX-1_IFDSP_V0107.SFL (New)
・SDR : FTX-1_SDR_V0106SFL (New)
・OPT : SPA-1_CTRL_V0113.SFL
Important: Please read the FTX-1 series Firmware Upgrade Manual,
Firmware_Ver_Up_Manual_ENG_FTX-1_2603A.pdf
Update Details (Web Release) (March 2026)
・WIRES-X Support Added
・Resolved an issue preventing manual tuning in CW mode when using the ATAS-120.
・Resolved a bug where the UPPER/LOWER display on the Scope would invert during
SSB transmission on the 50 MHz band.
・Other minor fixes.
Note: After completely installing the firmware, the FTX-1 must be reset.
Refer to the FTX-1 series Operating Manual Page 79.
Or refer to the Firmware_Ver_Up_Manual_ENG_FTX-1_2603A.pdf
If you already have the above firmwa
If you already have the above firmware versions, it is not necessary to update the FTX-1 again.
We hope this new firmware will increase your enjoyment of your FTX-1. Thank you for
choosing Yaesu radios. If you have any problems or questions, please contact Yaesu Amateur
Tech Support amateurtech@yaesu.com
Visitas: 156